Repetier Host Printer Configuration- Mac

Connection

Port: whichever port your printer is hooked up to
Baud Rate: 250,000
Stop Bits: 1
Parity: None
Transfer Protocol: Autodetect or Force ASCII Protocol
Receive Cache Size: 63
Use Ping-Pong Communication: Unchecked
Firmware send OK after error: Checked

Behaviour

Travel Feed Rate: 4800
Z Axis Feed Rate: 200
Default Extruder Temperature: 195
Default Heated Bed Temperature: 90
Number of Extruder: 1
Check extruder & heated bed: Checked
Check extruder & heated bed every: 3 seconds
Don't log temperature requests (M105): Checked
for the Solidoodle 2
Dump area position: X = 150, Y = 150, Z = 15
for the Solidoodle 3
Dump area position: X = 200, Y = 200, Z = 15
Go to dispose after job/job kill: Checked
Disable extruder after job/job kill: Checked
Disable heated bed after job/job kill: Unchecked
Disable motors after job/job kill: Checked
Add to comp. printing time: 8

Dimension, for Solidoodle 2

Home X = x max
Home Y = y max
Home Z = z min
X Min = 0
X Max = 159
Y Min = 0
Y Max = 150

Printer Type: Classic Printer
Print Area Width: 159
Bed Front: 0
Print Area Depth: 150
Bed Left: 0
Print Area Height: 150

Dimension, for Solidoodle 3

Home X = x max
Home Y = y max
Home Z = z min
X Min = 0
X Max = 205
Y Min = 0
Y Max = 170

Printer Type: Classic Printer
Print Area Width: 170
Bed Front: 0
Print Area Depth: 200
Bed Left: 0
Print Area Height: 200

Advanced

Filter Path and Parameter: leave blank
Run filter after every slice: Unchecked

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-ShareAlike 3.0 License